First, whether the furniture edging is flat
The edge banding is uneven, indicating that the inner material is wet, and the edge banding will fall off within a few days. Edge banding should also be rounded, not right-angled. The edges sealed with wooden strips are simply wet or cracked. For plywood-enclosed furniture, nails are used at the wrapping strips. Pay attention to whether the nail holes are flat and whether the colors at the nail holes are the same as those at other places. Generally, the nail holes are sealed with putty. Pay attention to whether the putty is bulging. If it is clarified, the putty will slowly fall out of it.
Second, take a picture of the mirror furniture
Choose furniture with mirrors, such as dressing tables, dressing mirrors, and dressing mirrors. Pay attention to the pictures to see if the mirrors are distorted. Check whether there is a liner and a backing sheet at the mercury at the rear of the mirror. Pass, no paper, otherwise the mercury will be worn off.
Third, the paint part should be lubricated
The painted part of the furniture should be smooth, free from wrinkles, and free from creases. The corners should not be right-angled, right-angled areas are liable to chipping and paint off. Inside the door of furniture should also be painted with a paint, without painting the board is easy to twist and not beautiful.
Fourth, is the fitting device reasonable?
Check if the door lock switch is not working. The large cabinet should be equipped with 3 concealed hinges, some of them cannot be installed; some of them should be reeled.
Fifth, sit on the sofa or soft bed
When picking a sofa or a soft bed, you should leave the accidental table flat and not uneven; the soft and hard should be uniform, but not this hard and the soft; the soft hardness should be moderate, neither too hard nor too soft.
The choice is to sit and hold your hands for a while. The flat springs will not ring. If the arrangement of the springs is not reasonable, causing the springs to bite, it will announce the sound. Secondly, we should also pay attention to whether there are broken lines or jumpers in the quilting, and whether the density of the corner teeth is reasonable.
